CLUTCH MASTER CYLINDER - DISASSEMBLY / ASSEMBLY NOTES
H-11prose procedureDisassembly Note
Snap ring
NOTE
Do not damage the push rod contact surface of the piston.
Press down on the piston and remove the snap ring with snap-ring pliers.
Piston and secondary cup assembly
CAUTION
Hold a rag over the master cylinder to prevent the piston and secondary cup assembly from jumping out.
Remove the piston and secondary cup assembly, spacer, and primary cup by applying compressed air through the clutch pipe installation hole.
Assembly Note
CAUTION
Before assembly, make sure all parts are completely clean.
Do not mix different brands of clutch fluid.
Do not reuse the clutch fluid which was drained out.
Apply the specified clutch fluid to the piston and secondary cup assembly, spacer, primary cup, and cylinder bore before assembly.
Replace parts with new ones whenever specified to do so.
Piston and secondary cup assembly
Install the spring, primary cup, spacer, and piston and secondary cup assembly, noting the proper direction of the parts. (Refer to page H-10.)
Snap ring
NOTE
Do not damage the push rod contact surface of the piston.
While pressing the piston, install the snap ring.