REAR AXLE — Disc Brake Type — Inspection / Removal / Installation

M-10prose procedure

DISC BRAKE TYPE

1
Inspect wheel bearing play, referring to Inspection.
2
Remove in the order shown in the figure, referring to Removal Note.
05U0MX-019
3
Inspect all parts and repair or replace as necessary.
4
Install in the reverse order of removal, referring to Installation Note.
5
After installation, adjust the rear wheel alignment. (Refer to Section R.)

Parts DiagramFig. fig1

#	Part Name	Notes
1	Rear wheel	Tightening torque 88—118 N·m (9—12 m-kg, 65—87 ft-lb)
2	Brake caliper assembly	Removal Note ... page M-11
3	Disc plate	—
4	Locknut	REPLACE; Installation Note ... page M-11; Tightening torque 216—294 N·m (22—30 m-kg, 159—217 ft-lb)
5	Knuckle, wheel hub, and dust cover	Inspect knuckle for cracks and damage; Inspect wheel hub for cracks and damage; Inspect dust cover for damage and distortion; Disassembly / Inspection / Assembly ... page M-12

Rear wheel

863 - 1157N·m

Fastener (upper, unlabeled)

46—67N·m (4.7—6.8 m-kg, 34—49 ft-lb)

Fastener (middle, unlabeled)

63—75N·m (6.4—7.6 m-kg, 46—55 ft-lb)

Caliper mounting bolt

49—69N·m (5—7 m-kg, 36—51 ft-lb)

Locknut

2118 - 2883N·m