AIR CONDITIONER
U-32parts diagramCOOLING UNIT
Removal / Installation
Cooling unit Removal / Installation
- 1Discharge the refrigerant system. (Refer to page U-28.)
- 2Remove the cooling unit as shown in the figure, referring to Removal Note.
05U0UX-053 - 3Install the cooling unit in the reverse order of removal, referring to Installation Note.
- 4Charge the refrigerant system. (Refer to page U-29.)
Parts DiagramFig. fig1
Removal note
Immediately plug all open fittings to keep moisture out of the system.
Installation note
Position the cooling unit so that its connections match those of the heater unit and the blower unit.
Apply clean compressor oil to the O-rings before connecting the fittings.
Do not apply compressor oil to the fitting nuts.
If the evaporator is replaced, add compressor oil to the compressor.
| Specification | Value |
|---|---|
| Compressor oil | 50 cc (3.05 cu in) |
Compressor oil
50 cc (3.05 cu in)
| Specification | Value |
|---|---|
| Inlet pipe | 9.8 - 20N·m |
| Outlet pipe | 20 - 29N·m |
Inlet pipe
9.8 - 20N·m
Outlet pipe
20 - 29N·m