AUDIO — Cassette Tape Player (cont'd), Compact Disc (CD) Player, Clock
T-112spec tableCassette Tape Player (cont'd)
Cassette Tape Player (cont'd) — Function / Operation and procedure / Display
Tape direction change
Operation and procedureTo change tape-playing direction, press PLAY/PRO
Display
Dolby B noise reduction
Operation and procedurePress when using tape encoded with Dolby NR
Display
Compact Disc (CD) Player
CAUTION
The CD player cannot play 8 cm (3.1 in) CDs. The smaller CD may dislodge from the adapter and damage the disc or the player. Use only standard 12 cm (4.7 in) CDs.
Compact Disc (CD) Player — Function / Operation and procedure / Display
Disc insert
Operation and procedurePush disc, label-side up, into slot. Auto-loading mechanism will take over to set disc and begin play
NOTE: There will be short lapse of time between time disc is set and play begins. This is because period of time is necessary for disc player to read digital signal on disc. When CD is pressed while disc is being played, play will pause. Play will resume when CD is pressed again
Display
Stopping/Playing CD
Operation and procedureTo stop CD play during playback without ejecting it, press PLAY/STOP (CD will be in pause mode)
To start playing CD again, press PLAY/STOP again
To play loaded CD directly from radio or tape mode, press PLAY/STOP
Display
Ejecting/Reloading CD
Operation and procedureTo eject CD, press EJECT/RELOAD
To reload ejected CD, press EJECT/RELOAD again
Display
Fast forward/reverse
Operation and procedureTo fast forward program, press FF
To reverse program, press REW
Display
Repeat play
Operation and procedureTo listen to program repeatedly, press RPT during play of selection to be repeated
Display
Music scan
Operation and procedureTo scan play, press SCAN
To cancel scan play, press SCAN again
Display
Track search
Operation and procedureTo search program tracks, press ∧ (for forward) or ∨ (for reverse)
Display
Clock
NOTE
The clock can be set while radio or tape/CD player is ON.
Clock — Function / Operation and procedure
Time display
Operation and procedureTime is normally displayed. Pushing CLOCK will automatically display current radio frequency or mode for approx. five seconds before reverting to time mode.
Setting clock
Operation and procedureTo adjust time, press CLOCK for approx. two seconds, current time will flash
To advance hours, press △ , to advance minutes, press ▽
NOTE: If time is not adjusted while clock's current time is flashing (If neither △ nor ▽ is pressed) and CLOCK is pressed second time, minutes will be set to 00.
If clock's current time setting is within latter part of hour (from 30 to 59 min) hour setting will automatically advance one hour.
To resume normal display, press CLOCK again