LIGHTING SYSTEM — Step 8 (DRL connector check) & Symptom: Turn signal(s) flashes rapidly
T-67prose procedureDRL section applies to Canada-spec only (daytime running lights).
Step 8
Measure the voltage at the terminal-wires of the DRL connector as shown.
Step 8 DRL connector voltage check
(G/W)
ConditionTurn signal switch right position
Voltage12V
ActionNext, check wire (G/Y)
(G/W)
ConditionTurn signal switch right position
Voltage0V
ActionRepair wire (G/W) (Flasher unit—DRL unit)
(G/Y)
ConditionTurn signal switch right position
Voltage12V
ActionRepair wire (G/Y) (DRL unit—Bulb)
(G/Y)
ConditionTurn signal switch right position
Voltage0V
ActionCheck DRL unit (Refer to page T-18)
(G/B)
ConditionTurn signal switch left position
Voltage12V
ActionNext, check wire (G/O)
(G/B)
ConditionTurn signal switch left position
Voltage0V
ActionRepair wire (G/O) (Flasher unit—DRL unit)
(G/O)
ConditionTurn signal switch left position
Voltage12V
ActionRepair wire (G/O) (DRL unit—Bulb)
(G/O)
ConditionTurn signal switch left position
Voltage0V
ActionCheck DRL unit (Refer to page T-18)
Symptom: Turn signal(s) flashes rapidly
Remedy
Check the bulbs and the wiring harness between each bulb and the body ground (rapidly flashing side).
NOTE
Rapid flashing is a flasher unit function to warn of a bad bulb or an open circuit.